Breckwell SPC50 Installation Manual download pdf (Page 5)

FLOOR PROTECTION

This heater must have a non-combustible ﬂ oor protector (ember protection) installed beneath it, if the ﬂ oor is of combustible

material. If a ﬂ oor pad is used, it should be UL listed or equal. The ﬂ oor pad or non-combustible surface should be large enough

to cover at least the area under the product and extend beyond the front and each side of the fuel loading and ash removal openings

as shown below. A Floor Protector of ¼ inch thick is recommended for this installation.

SPECIAL MOBILE HOME REQUIREMENTS

 WARNING! - DO NOT INSTALL IN A SLEEPING ROOM

 CAUTION! - THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ROOF

MUST BE MAINTAINED.

In addition to the previously detailed installation requirements, mobile home installations must meet the following requirements:

1) The heater must be permanently attached to the ﬂ oor.

2) The heater must be electrically grounded to the steel chassis of the mobile home with 8 GA copper wire using a serrated or star

washer to penetrate paint or protective coating to ensure grounding.

3) When moving your mobile home, all exterior venting must be removed while the mobile home is being relocated. After relocation,

all venting must be reinstalled and securely fastened.

4) Outside Air is mandatory for mobile home installation. See your dealer for purchasing.

5) Check with your local building ofﬁ cials as other codes may apply.

k wall / Arrière Mur

Dimension Inch mm

H* Front 6 153

J Flue rear 2 51

K** Left 6 153

L** Right 6 153

M Flue Side 2 51

⃰ Canadian installations require 18” (457mm)

⃰ ⃰ Canadian installations require 8” (203mm)

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Breckwell SPC50 Installation Manual Page 5